SERVICE & TROUBLESHOOTING

ZIPP 3ZERO Moto

• If my TyreWiz breaks, can I install a normal tubeless valve?
Yes. You will need to remove the complete TyreWiz device and valve to make this change. It can be done by hand without tools. See more
• If spokes are slightly too long and extend past the end of the spoke nipple, will it poke through the rim tape?
Yes. It is critical to use the right length spokes when building 3ZERO MOTO wheels. See more
• Is there a specific spoke tension required when building Zipp 3ZERO MOTO wheels?
Yes. Proper spoke tension is critically important to proper function of the 3ZERO MOTO’s design. Rear drive-side and front non-drive side spoke tension must be 115Kgf. See more
• Do 3ZERO MOTO rims need to be built with a particular spoke lacing pattern?
Yes. 3-cross. See more
• Are there specific spoke and spoke nipple types or brands that Zipp recommends for building 3ZERO MOTO rims?
There are no specific spoke types required, however, wheel builders should keep in mind that using lighter spokes will produce a wheel with greater lateral flex when compared to a typical 2.0/1.8 s... See more
• Can rims be built using either alloy or brass spoke nipples?
Yes. See more
• Are spoke nipple washers required?
Yes. They are supplied with each rim. See more
• Do I need some sort of lubrication between the washer and the nipple head for the Zipp 3ZERO MOTO?
No. See more